C. MAINTENANCE
The only maintenance operation required is the removal of dirt and lint from the condenser of the water cooler. Inspection should be made at 3
month intervals. Disconnect the power supply cord, then clean the condenser with a small stiff non-
wire brush when required. Observance of this
procedure will ensure adequate air circulation through the condenser so operation is efficient and economical.
D. OVERLOAD PROTECTION (water cooler)
The compressor motor, where used, is equipped with an automatic reset protector which will disconnect the motor from the line in case of an
overload.
E. LUBRICATION (water cooler)
This unit is equipped with a hermetically sealed compressor and requires no additional lubrication. The fan motor on this un
oiling, but if required, a few drops of SAE 10 oil should be used.
F. TO DISCONTINUE USE OF WATER COOLER AND WATER FOUNTAIN
1. Close water shut off valve.
2. Provide container to catch water to be drained.
3. On push button model, disconnect power supply cord then disconnect water supply line at shut off valve. Route water supply line to
container and actuate push button. If this drains too slowly for you, prepare 3/8” ID tube or 3/8” OD tube with quick-connect fitting and
remove screw plug in tank drain. Slide tube over drain and route to container. Replace screw plug when draining is complete. Do not over-
tighten. O-ring only needs to be snug to seal.
4. On TM and TT models, disconnect water supply line at shut off valve. Place water supply line in container and actuate solenoid as
explained in Step B12. If this drains too slowly for you, disconnect power supply cord and prepare 3/8” ID tube or 3/8” OD tube with quick-
connect fitting and remove screw plug in tank drain. Slide tube over drain and route to container. Replace screw plug when draining is
complete. Do not over-tighten. O-ring only needs to be snug to seal.
5.
ALWAYS DRAIN ALL WATER WHEN FREEZING TEMPERATURES ARE ANTICIPATED AND BEFORE SHIPPING THE
WATER COOLER.
*American With Disabilities Act
WARNING
The warranty and the Underwriters' Laboratory listing for this machine are automatically voided if this machine is altered, mod
ified, or combined with any other machine or device. Alteration or
modification of this machine may cause serious flooding and/or hazardous electrical shock or fire.
EXCEPT AS SET FORTH HEREIN, THE MANUFACTURER MAKES NO OTHER WARRANTY, GUARANTEE OR AGREEMENT EXPRESSED, IMPLIED OR
STATUTORY, INCLUDING ANY IMPLIED WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
OASIS INTERNATIONAL
222 East Campus View Blvd. • Columbus, OH 43235 U.S.A.
1-800-950-3226
www.oasiscoolers.com
OASIS is a registered trademark of LVD Acquisition, LLC dba Oasis International © 2020 LVD Acquisition, LLC
A WBENC – Certified Women’s Business Enterprise 030099-350 Rev. E, Date 4/2020
To Next Page
Loading...
