9
Infrared Turret Camera User Manual
SECTION 2: INSTALLATION
8. With the camera in the camera housing, route the drop cable through the 3/4" hole
until the camera housing is tted onto the base. Place the housing bezel over the
camera housing and screw it onto the base until the camera and camera housing are
held in place. Skip to step 12.
9. Set the camera on the base with the camera cable pressed into one of the cable
guides of the base. Allow some slack in the cable within the base to allow for camera
positioning later.
10. Use a #2 Phillips screwdriver to mount the base with the provided screws.
11. Without allowing the camera to hang by the drop cable, place the camera module
onto the base, cover with the camera housing, then move the bezel into place. Screw
the housing bezel onto the base until the camera and camera housing are held in
place.
To Next Page
Loading...
