Occhio Puro - Replacing the Light Source

26
Replacing the light source
If necessary, loosen the xing screw and
remove the reector head (see p. 25).
Caution
Switch off the light before replacing
the reector head and allow it to cool
down for at least one hour.
$
Hold the bulb with a soft cloth and with-
draw it from the socket.
Insert the bulb into the socket of the
socket holder.
Only handle the bulb using a soft cloth.
Wipe away ngerprints before switching
on.
The power of the light source must be
matched to the lamp body.
Fitting the appropriate light source is
described separately in the enclosed
instructions for the respective lamp.
Slide the reector head onto the socket
holder. It engages when pushed to its end
position.
If necessary, slightly tighten the xing
screw.