What to do if the Ocean Optics DH-2000-BAL Lighting Equipment power is on but no LEDs light?
If the power switch is on but no LEDs are lighting up, check if line power is present. Also, check the fuse to see if it is defective.
Why doesn't the Deuterium lamp light on my Ocean Optics DH-2000-BAL Lighting Equipment?
If the Deuterium lamp doesn't light and the LED is red, it could be due to several reasons. First, the Deuterium lamp might be too hot; allow it to cool down for 20 minutes, then press the On/Off switch again to reset and restart it. Second, the lamp life may be exhausted, requiring a replacement. Finally, the lamp’s internal connection plug may not be closed correctly; open the unit (see the Maintenance) and close the connector plug.
What to do if the Halogen lamp doesn't work on Ocean Optics Lighting Equipment?
If the Halogen lamp doesn't work after pressing the On/Off switch, it could be because the Deuterium lamp is still warming up; wait until the Deuterium lamp has lit and try again. Alternatively, the Halogen lamp may be defective and require replacement.
What to do if the Deuterium lamp turns off during operation in Ocean Optics DH-2000-BAL Lighting Equipment?
If the Deuterium lamp turns off during operation, the lamp may be too hot. Turn off the unit and allow it to cool down for at least 20 minutes. Once cooled, turn the Deuterium lamp back on.
What to do if the LED does not light after switching on the Halogen lamp on Ocean Optics Lighting Equipment?
If the LED does not light after switching on the Halogen lamp, the internal power supply might be defective. Disconnect the unit from the main power source and contact your dealer for repair or replacement.
Crucial safety information including protective eyewear and avoiding direct beam exposure.
Detailed procedure for carefully unpacking the DH-2000 unit and checking for damage.
Instructions for connecting the power cord and interface cable to the DH-2000 unit.
Procedure for connecting the fiber optic cable to the SMA connector on the DH-2000.
Overview and description of components and controls on the front panel of the DH-2000.
Overview and description of components and connectors on the rear panel of the DH-2000.
Detailed technical specifications for Deuterium and Tungsten-Halogen lamps.
Troubleshooting common issues related to the Deuterium lamp.
Troubleshooting common issues related to the Halogen lamp.
General| Brand | Ocean Optics |
|---|---|
| Model | DH-2000-BAL |
| Category | Lighting Equipment |
| Language | English |
To Next Page
