EasyManuals Logo

Ocean Signal AIS-MOB1 User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
MOB1 USER MANUAL
3 Version 01.00 13/02/2015
IN CASE OF EMERGENCY
Use only in situations of grave
or imminent danger
If the MOB1 is correctly fitted to the life jacket, then the MOB1 will automatically
activate when the life jacket inflates. This guide shows how to manually activate
the MOB1.
Slide the red Arming Tab down (1)
Slide the grey Activation Slide (2) sideways by pulling on the
attached tape and remove. This will release the antenna and
activate the MOB1
If the strobe light does not start flashing, manually switch the
MOB1 on by pressing the ON Key (3)
Always turn off the MOB1 immediately after you have been rescued to avoid
interference with other users. Refer to section 5.4 for deactivation instructions.
3
1
2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ocean Signal AIS-MOB1 and is the answer not in the manual?

Ocean Signal AIS-MOB1 Specifications

General IconGeneral
BrandOcean Signal
ModelAIS-MOB1
CategorySafety Equipment
LanguageEnglish

Related product manuals