MOB1 USER MANUAL
8 Part No 912S-01517
• Pass the tape around the bladder of the life jacket and clip the
bracket to the MOB1 so that the MOB1 will be on the outside
of the inflation tube as shown.
• Pull the tape tight with the free end of the tape, so that
the bladder is free to inflate and remains folded in
accordance with the life jacket manufacturer’s
instructions. Do not over tighten the tape.
Test for tightness by ensuring you can freely insert a
finger in between the tape and the bladder.
• Once the MOB1 is fully attached to the life-jacket, you are
ready to arm the device, by sliding the red arming tab down.
Failure to arm the MOB1 will inhibit the auto
activation of the MOB1 when needed and will STOP
the life jacket inflating correctly.
If the MOB1 has turned on during the installation
process, make sure it is turned off by pressing and
holding the TEST/OFF Key until the LED flashes red
twice and release.
• Repack the bladder into the cover, ensuring the bladder does not get trapped in the
fastening mechanism or tangled up.
For installation to life jackets where the bladder is permanently attached to the
cover, please see the separate instruction sheet, available from the Ocean
Signal website.
To Next Page
Loading...
Need help?
General
