Ocean Technology Systems Guardian - Post-Dive Procedures; Warning Note; Part Lists; Accessories Included

16
Post-Dive Procedures
After you have completed your diving, remove the mask from the regulator
(see “Regulator Set-Up and Hose Conguration” on page 8) by
disengaging the regulator with the quick-release button on the inside of
the mask. Thoroughly rinse the mask in clear, fresh water and pat it dry
with a lint-free absorbent cloth. If necessary, a mild detergent may be
used for cleaning the mask. Never use any harsh detergents, abrasives,
or solvents on your Guardian FFM. Use caution when drying the visor after
diving in a sandy environment to prevent any scratching of the lens. Do
not use paper towels to dry or clean visor—they tend to scratch the lens.
Warning Note
If the mask has been exposed to contaminated water it should be
disassembled and cleaned by an OTS certied technician
Hang the mask upside down to allow for any trapped water to drain to the
top of the skirt. Wipe out the excess water and allow the mask to air dry
prior to storing in the mask bag. If traveling requires you to stow a damp
mask, remove it from the bag as soon as possible and allow it to dry
completely (to prevent any mold and mildew from forming).
Rinse the regulator as you normally would your regulator assembly. Flush
the regulator with fresh water. Do not push the purge button when rinsing
the second stage. Shake any remaining water from the regulator and stow
it with the assembly.
PART LISTS
Accessories Included
In addition to the Guardian FFM and Regulator, each Guardian FFM
System comes with the accessories listed in Table 1.
Table 1: List of Accessories Included
Part Number Description
134153-001 CASE, FULL-FACE MASK, CUSTOM OTS (“OTS Bag”)
604018-001 HOSE, SCUBA, STANDARD, 34”
920010-000 OTS-ABV-2 (installed)
506129-000 MANUAL, OPERATION, OTS FFM (“Owner’s Manual”)
910385-000 EQUALIZING KIT, OTS, FFM
137053-000 WRENCH, VALVE BASE, REGULATOR (“OTS Wrench”)