Need help?Do you have a question about the OCEANAIRE PWC Series and is the answer not in the manual?
Explains the naming convention and model designations for PWC units.
Details the manufacturer's limited warranty coverage for the PWC series units.
Specifies the operational temperature range for the PWC cooling function.
Describes the construction and features of the PWC unit's metal cabinet.
Details the non-programmable electronic thermostat controlling unit operation and comfort.
Explains the rocker switch for selecting high or low evaporator fan speeds.
Describes the automatic condensate pump system and its overflow alarm functionality.
Explains the function of the red condensate alarm light on the unit's front.
Details the washable evaporator air filter located behind the return air grille.
Describes the manual reset switch protecting the compressor from high pressure conditions.
Information on the standard power cords, including LCDI devices for safety.
Explains the use of PWC units for cooling specific areas or "spots".
Describes how PWC units function as room air conditioners using water for heat rejection.
Provides a general overview and description of the PWC unit's operation.
Details optional nozzle kits for directing conditioned air to specific target areas.
Explains plenums for connecting ductwork to the evaporator return air inlet.
Describes adapters for connecting round ductwork to the evaporator discharge.
Information on available hose kits for convenient water supply and drain connections.
Option for condenser coils resistant to treated water, saltwater, or brine.
Valve option for applications with high water supply pressures exceeding 150 psig.
Option for evaporator coils treated for use in chemically corrosive environments.
Valve to regulate evaporator temperature and prevent freeze-ups in low ambient conditions.
Water valve constructed with naval bronze and MONEL parts for corrosion resistance.
Units built for direct water connection without a water valve in closed-loop circuits.
Procedure for inspecting the unit packaging and condition upon receipt.
Pre-installation checks and recommendations for unit damage inspection.
Guidance on verifying proper power supply and NEMA receptacle compatibility.
Steps for initial unit installation, connection, and testing for proper operation.
Instructions for using the FAN slide switch to select ON or AUTO fan modes.
How to turn the unit ON or OFF using the MODE slide switch.
Guide to adjusting the set-point temperature using the up and down arrow buttons.
Step-by-step guide for replacing the evaporator fan motor assembly.
Procedure for removing and installing the thermostat and its sub-base.
Instructions for replacing the condensate alarm indicator light.
Steps for removing and installing the condensate pump unit.
Guide for accessing and replacing the high pressure safety switch.
Diagnosing and resolving issues when the unit fails to power on.
Troubleshooting steps for a blank thermostat display after powering the unit.
Identifying causes and solutions when the fan operates but the compressor does not.
Procedures for preparing the unit for storage during the off-season.
Steps to drain water from the condenser coil and interior water lines.
Instructions for draining water from the installed hose kits.
Guide for removing water from the condensate pump reservoir and servicing the pump.
Instructions for washing unit coils and filters and allowing them to dry.
Information regarding the permanently lubricated bearings of the evaporator blower motor.
Recommendations for inspecting and cleaning the evaporator air filter regularly.
General advice on unit storage and servicing by qualified technicians.
Details on the ICM401/ICM402 phase monitor and its LED indicators for operation and faults.
Information on the SSAC phase monitor, its LEDs, and troubleshooting for three-phase units.
General| Brand | OCEANAIRE |
|---|---|
| Model | PWC Series |
| Category | Accessories |
| Language | English |
To Next Page