26
POST DIVE CARE
As soon as possible at the end of each day of diving:
Install the first stage protector cap and tighten the yoke knob (or install the DIN thread
protector cap).
If possible, immerse the entire regulator assembly in a warm fresh water bath and
soak for one hour, preferably while pressurized. DO NOT depress the second stage
purge button while the regulator is soaking. Doing so will allow water to flow into the
sealed portion of the first stage.
Remove from the bath and rinse all components of the assembly with slow running
fresh water. DO NOT use full water pressure.
Flush the ambient openings of the first stage and the exterior of all components thor-
oughly to remove dissolved salt and other contaminants.
If the first stage is configured with a rubber-like boot, direct rinse water through the
flow-through slots.
Flush the second stage by running water into the mouthpiece and out the exhaust
ports. DO NOT depress the purge button while rinsing., doing so will allow water to
enter the first stage.
If possible, lay the complete assembly flat in a cool, dry place
(out of direct sun-
light)
and allow the components to dry naturally.
DO NOT inject or spray lubricants into or onto the first and second stages. Doing so
can attract contamination that may subsequently interfere with proper operation.
To Next Page
Loading...