46
a. COOLING Mode:
The air is cooled and the hot air is exhausted to the outside through the exhaust hose.
Adjust the fan speed and the temperature setpoint according to the ambient temperature.
The cooling function turns off when the room temperature is below the set temperature.
Ventilation, however, continues to operate at the set level. The cooling function starts again
as soon as the room temperature exceeds the set temperature.
The set temperature can be set between 16 ° C and 31 ° C
b. DEHUMIDIFICATION Mode:
When the DEHUMIDIFICATION mode is selected, the fan speed can not be adjusted. By
default, this will be set to the slowest speed. The « Sleep » function can not be adjusted.
Only the timer function can be configured.
Note :
- It is not necessary to use the drain hose in the DEHUMIDIFICATION mode.
- Windows and doors must be kept closed.
- Continuous drainage can be achieved by connecting a drain hose to the back of the
unit.
c. VENTILATION Mode:
When the VENTILATION mode is selected, the air circulates in the room without being
cooled.
Only the timer function and the fan speed can be configured.
Note :
- It is not necessary to use the drain hose in VENTILATION mode.
- The temperature and « Sleep » function can not be adjusted.
3. TEMPERATURE ADJUSTMENT:
The keys are used to adjust the temperature setpoint. This setting is configurable
only in cooling mode.
By pressing the "UP" or "DOWN" button, the set temperature is displayed on the screen.
To Next Page
Loading...
Need help?
General