Oclean W10 - Instruction for use; Install the nozzle; Inject water into the water compartment; Switching button

7
Instruction for use
1. Install the nozzle
Insert the nozzle into the
main body of the oral
irrigator.
2. Inject water into the
water compartment
Lid and inject clean water,
the water temperature is
appropriate to feel
comfortable
(recommended not to
exceed 40°C), then close
the lid, and the installation
is completed.
3. Switching button
Perform a short press on
the “mode button” to
switch modes.
4. Preparation before use
Before use, please bend down slightly and extend the nozzle into your mouth, aim the
teeth, gaps among teeth or gums to ensure that the water flow is perpendicular to
irrigation positions, and at the same time, open your mouth slightly so that the irrigation
water can flow out of your mouth.
Warm tips:
The first time you use the oral irrigator, you may experience itching or slight gum
bleeding. This phenomenon usually stops within 1 to 2 weeks, if it exceeds 2 weeks, it
may indicate that your gums are abnormal, please stop using the oral irrigator and
consult the dentist.
5. Irrigation operation
Press the on-off button to start using this product. This product has a 2-munute timed
shutdown function, if you need to continue, please press the on-of button again and
make sure that there is water in the water compartment. If you need to pause during
use, please press the on-off button, and if you need to continue, please press the on-off
button again.