8 97
11 1210
13 14 15
3
8
Empty the container with the
used descaling solution.
Press the button to turn off the
machine. After 10 minutes, turn
on the machine again.
Repeat steps 3 - 8 until all the
descaling solution in the tank
has been dispensed.
Rinse and fi ll the tank with fresh
drinking water.
Press the hot water button. Place a large container beneath
the steam spout.
Turn the knob until the
position is reached to empty the
water tank.
When this operation is completed,
turn the knob until it is in the rest
position ( ).
Press the hot water button
for 6 seconds to disable the
descaling alarm.
Fill the tank again with fresh
drinking water.
Once descaling has been performed:
1. Install the “Aqua Prima” fi lter, if available;
2. Prime the circuit as described on page 7, from step 7.
DESCALING
To Next Page
Loading...
Need help?
General