2 3
4 6
7
5
1
Press the “PUSH” button to
remove the Brew Group.
Make sure the Brew Group is in
rest position; the two references
must match.
Wash the Brew Group with
running water. Wash fi lters
carefully.
CLEANING THE BREW GROUP
The Brew Group must be cleaned at least once a week. Before removing the Brew Group, remove the
coffee grounds drawer as shown in fi g. 4 on page 17. Once you have washed and inserted the Brew
Group, insert the grounds drawer and close the service door.
Make sure the components are in
the correct position.
The hook shown must be in the
correct position; to check its
position, fi rmly press the “PUSH”
button.
Insert the washed and dried Brew
Group.
DO NOT PRESS THE “PUSH”
BUTTON.
Insert the grounds drawer and
close the service door.
The lever on the rear part of the
group must be in contact with
the brew group base.
CLEANING AND MAINTENANCE
To Next Page
Loading...
Need help?
General