Transmission (Main Gear case)
Always check and change the fluid at the intervals outlined in the Periodic
Maintenance Chart beginning on page 46. Yours recommends the use of
Premium AGL Synthetic Gear case Fluid for this vehicle.
The fill plug is located on the rear of the
Gear case. Access the fill plug through the
left rear wheel well. Maintain the fluid
level at the bottom of the fill plug hole.
1.Locate the vehicle on a level surface.
4.Add the recommended fluid as
5.Reinstall the fill plug.
The drain plug is located on the bottom of the gear case.
2.Place a drain pan under the drain plug.
3.Remove the drain plug. Allow the fluid to drain completely.
5.Reinstall the drain plug with a new o-ring. Torque to 11ft. lbs. (15Nm).
6.Add 20.3 oz. (600 ml) of the recommended fluid to the fill hole.
Maintain the fluid level at the bottom of the fill plug hole. Do not
7.Reinstall the fill plug.
9.Discard used fluid properly.