Cleaning and Storage
Washing the Vehicle
If a high pressure water system is used for cleaning (not recommended),
exercise extreme caution. The water may damage components and could
remove paint and labels. Avoid directing the water stream at the following
● Wheel bearings
● Radiator
● Transmission seals
● CVT inlet and outlet ducts
● Brakes
● Cab and body panels
● Labels and decals
● Electrical components and wiring
If an informational or graphic label becomes illegible or comes off, contact
your Yours dealer to purchase a replacement. Replacement safety labels
are provided by Yours at no charge.
Grease all zerk fittings immediately after washing. Allow the engine to run for
a while to evaporate any water that may have entered the engine or exhaust
Yours recommends the use of common household aerosol furniture polish
for polishing the finish on your Yours vehicle. Follow the instructions on the
● Avoid the use of automotive products, some of which can Scratch the
● Always use clean cloths and pads for cleaning and polishing. Old or reused
cloths and pads may contain dirt particles that will a scratch the finish.
To Next Page
Loading...
Need help?
General
