Seat Belts
Seat Belt Inspection
Inspect all belts before operation of each vehicle.
1.Push the latch plate into the buckle until it clicks. The latch plate
must slide smoothly into the buckle. A click indicates that it's
2.Push the red release latch in the middle of the buckle to make sure it
3.Pull each seat belt completely out and inspect the full length for any
damage, including cuts, wear, fraying or stiffness. If any damage is
found, or if the seat belt does not operate properly, have the seat belt
system checked and/or replaced by an authorized Yours dealer.
4.To clean dirt or debris from the seat belts, sponge the straps with
mild soap and water. Do not use bleach, dye or household detergents.
To Next Page
Loading...
Need help?
General
