ODES UTV Series User Manual

OPERATION
- 33 -
Starting the Engine
1. Turn the fuel valve on.
2. Sit in the driver's seat and fasten the seat belt.
3. Secure the cab nets.
4. Place the transmission in neutral. Set the parking brake.
5. Apply the brakes.
6. Do not press the throttle pedal while starting the engine.
7. Turn the ignition key past the ON/RUN position to START. Engage the
starter for a maximum of five seconds. Release the key when the engine
starts.
NOTICE: Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.
8. If the engine does not start within five seconds, return the ignition switch
to the OFF position and wait five seconds. Repeat steps 7 and 8 until the
engine starts.
If your vehicle has Hand-choke:
Tip: If a warm engine has cooled to a point where it does not readily start,
intermittent use of the choke (pulled half way out) may be necessary. If
the engine is over-choked when warm, depress the throttle lever fully
while cranking to aid in starting. Release the throttle lever immediately
after the engine starts. If the engine does not start and all conditions
are favorable, change the spark plug and try again.
9. Vary the engine RPM slightly with the throttle to aid in warm-up until the
engine idles smoothly.
10. Release the parking brake before driving.

ODES UTV Series Specifications

General

Brand	ODES
Model	UTV Series
Category	Offroad Vehicle
Language	English