Odor Crusher Ozone Closet

To Next Page

Ozone Machine

Hanging Bracket

STEP 7B. Hang Ozone

Machine by inserting Hanging

Bracket through the shelf rack.

STEP 6. Once the frame is fully assembled, place the

fabric shell over the frame to complete assembly.

An opening is located on either side of the back of the

fabric to allow the Ozone Machine power cord to run

through and plug into a wall outlet.

STEP 7A. Hanging option for

the Ozone Machine. Attach the

Hanging Bracket on the back of

the Ozone Machine.

See the

Ozone Machine Instruction Manual

for operating settings.

CAUTION! Read the Ozone Machine

Instruction Manual and warning label tags

carefully before operation.

V061416

Ozone Closet – Instructions for Assembly

Customer Service Line: 1-877-575-3173

One Year Limited Warranty

www. odorcrusher.com

MoJack Distributors, LLC

3535 N. Rock Road, Wichita, KS 67226

1-877-575-3173

www.theMoJack.com

NEED HELP? Please contact our customer service line

BEFORE returning to the store. For help with assembly,

or if you are missing a part, please call our Customer Service

Department at 1-877-575-3173.

STEP 5. Place the assembled top

section onto the top of the vertical

poles. Assembly of the frame is

now complete.

STEP 4. Continue building

up from the assembled middle

section by inserting poles

(D) and (E) and end connectors

(A1) and (A2) as the diagram

shows.

STEP 2. Building

up from the

assembled bottom

section, insert poles

(D) and (E) and

end connectors

(A1) and (A2) as

the diagram shows.

STEP 1. Start by assembling the top and bottom sections. Insert parts (B) and (C)

into parts (A1) and (A2) as shown below. Insert one hanging rod (F) into top section.

Note: Short shelf (C) should

be inserted into the stickered

side of (A2).

Bottom Section:

Top and Middle Sections:

Note:

All metal parts

must be inserted rmly and

completely into the plastic parts.

C 5 ea

Short Shelf

B 3 ea

Long Shelf

E 16 ea

Short Vertical Pole

F 2 ea

Hanging Rod

D 4 ea

Long Vertical Pole

A2 3 ea

End connector

A1 10 ea

End connector

STEP 3. Place the assembled

middle section onto the top of

the vertical poles.

Need help?

Do you have a question about the Odor Crusher Ozone Closet and is the answer not in the manual?

Summary

Ozone Closet Assembly Guide

Parts Identification

Lists all components required for assembly, including connectors, shelves, poles, and hanging rod.

Step 1: Assemble Top and Bottom Sections

Assemble top and bottom sections using parts B, C, A1, A2, and F, inserting one hanging rod.

Step 2: Build Bottom Section Upwards

Insert poles (D, E) and connectors (A1, A2) into the assembled bottom section as shown.

Step 3: Attach Middle Section

Place the assembled middle section onto the top of the vertical poles.

Step 4: Continue Building Upwards

Continue building up by inserting poles (D, E) and connectors (A1, A2) to the middle section.

Step 5: Place Top Section

Position the assembled top section onto the vertical poles to complete frame assembly.

Step 6: Attach Fabric Shell

Cover the assembled frame with the fabric shell, noting cord access for the ozone machine.

Step 7: Install Ozone Machine

Attach the hanging bracket to the Ozone Machine and then hang it on the shelf rack.

Customer Support and Warranty Information

Provides customer service contact details, warranty information, and company website.