OEG DD3 - Page 18

18 English
P1.11
FIRST DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed rst in the info line.
0 - no display
1 - room temp.
2 - auxiliary temp.
3 - domestic water temp.
4 - humidity
5 - air pressure
6 - auxiliary sensor (AUX)
11 - T1 controller sensor
...
22 - T12 controller sensor
P1.12
SECOND DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed second in the info line.
Setting range is identical
to parameter P1.11.
Factory setting is:
3 - domestic water
temperature
P1.13
THIRD DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed third in the info line..
Setting range is identical
to parameter P1.11.
Factory setting is:
4 - humidity
P1.14
FOURTH DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed fourth in the info line.
Setting range is identical
to parameter P1.11.
Factory setting is:
5 - air pressure
P1.15
FIFTH DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed fth in the info line.
Setting range is identical
to parameter P1.11.
Factory setting is:
0 - no display
P1.16
SIXTH DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed sixth in the info line.
Setting range is identical
to parameter P1.11.
Factory setting is:
0 - no display
P1.17
SEVENTH DISPLAY IN THE INFO LINE
This setting determines which information will be
displayed seventh in the info line.
Setting range is identical
to parameter P1.11.
Factory setting is:
0 - no display
P1.18
NUMBER OF INFORMATION ON BASIC DISPLAY
This setting determines how many lines of informati-
on will be displayed on the basic display.
1 ÷ 9 (1)