To Next PageTo Next Page
Need help?Do you have a question about the Oemtools 24887 and is the answer not in the manual?
General| Brand | Oemtools |
|---|---|
| Model | 24887 |
| Category | Air Cleaner |
| Language | English |
Check for loose, missing, or damaged parts after unpacking.
Read and retain safety instructions for safe use.
Read the manual to understand applications, limitations, and hazards.
Wear eye protection, dust mask, and safety shoes when appropriate.
Do not operate near flammable materials or combustibles.
Use only qualified personnel and identical replacement parts.
Avoid accidental fire; do not smoke near the product.
Thoroughly read and understand the manual before use.
Avoid wet hands, unplug when not in use, and use GFCI plugs.
Do not use if cord/plug is damaged; unplug by holding plug.
Avoid extension cords; use UL listed if necessary, do not chain.
Do not use near heat sources or flammables; avoid smoking.
Never insert hands or objects into moving fan housing.
Do not use with solid-state speed control devices.
Do not submerge the unit in liquids.
Do not expose electrical connections to water.
Do not touch electrically live components.
Do not open the electrical box while the product is in use.
Plug unit into a grounded 110-120V AC outlet.
UL GFCI plug interrupts power for safety; reset if tripped.
Fill Water Tank to 50% capacity, observe water inlet pressure limit.
Switch power ON, then pump ON for 2-3 minutes to saturate pads.
Always unplug the unit from the power source before performing maintenance.
Do not use water to clean the fan, electrical components, or control panel.
Do not attempt maintenance on motor/electrical systems; contact service if unsure.
Check power supply, reset breaker, or contact electrician if unit won't start.
Verify cooling pad saturation, water level, pump status, and insertion.
