What to do if OGSI OG-15 Oxygen Equipment purity is not reached after 30 minutes?
If your OGSI Oxygen Equipment has run for 30 minutes and purity has not yet been reached, use a leak testing solution to locate and repair any air leaks.
What to do if valves are sticking in OGSI OG-15?
If the valves are sticking in your OGSI Oxygen Equipment, this may be due to dusting of the sieve or the machine being filled with dirt and dust because air filters have not been replaced. Remove the valve block from the machine and clean the valves and spools completely.
How to prevent dusting of sieve beds in OGSI OG-15?
Dusting of sieve beds in OGSI Oxygen Equipment can occur due to a contaminated sieve, moisture in the air, or dry air not being fed to the machine. Here are some steps to take:
What to do if pressure switch is not functioning in OGSI OG-15 Oxygen Equipment?
If the pressure switch is not functioning in your OGSI Oxygen Equipment, this may be due to a faulty switch. Remove the switch and return it for a replacement.
Remove packaging material inside the unit and install the air inlet filter before operation.
Guidance on selecting an indoor location with specific temperature and clearance requirements.
Recommendations for power outlet proximity and prohibition of extension cords.
Specifies indoor use, NEMA12 protection, and environmental quality for optimal operation.
Emphasizes cool, dry, clean air quality and temperature range for generator longevity.
Details U.S. power supply specs, dedicated circuit needs, and prohibition of extension cords.
Specifies air pressure, flow rate, and quality for compressor-less models.
Steps for connecting, powering on, waiting for purity, setting pressure, and opening flow.
Instructions for temporarily stopping flow and fully shutting off the machine.
General| Brand | OGSI |
|---|---|
| Model | OG-15 |
| Category | Oxygen Equipment |
| Language | English |
To Next Page