The OTS lock can be installed in lockers up to 20 mm thick.
The assembly of the lock in the locker door must be correctly carried out to ensure the correct operation of the lock.
The position of the xing holes and the distance from the lock to the locker body, as shown in gures 1.2 and 1.3, must be correctly carried out to
prevent the knob from seizing up and the tab from being blocked.
If the tab becomes blocked due to incorrect installation, it can be unblocked by pressing the door inwards and pulling the knob outwards.
OTS
®
BASIC
ASSEMBLY INSTRUCTIONS
TECHNICAL DRAWINGS
OTS LOCK INSTALLATION AND ASSEMBLY
23 35
14
5
22,4Ø
5,75
41,3
30
93,5
93,5
11,3
118
8
109,5
51,6
25,5
15
OTS
®
RFID LOCK
E-30
To Next Page
Need help?
General
