CLEANING AND CARE
• Warning! When cleaning, never use solvents or abrasive materials, hard brushes, metallic or sharp
objects. Solvents are harmful to human health and can attack plastic parts, while abrasive cleaning
mechanisms and tools may scratch the surface(s).
• Clean the exterior surfaces of the product with a slightly damp cloth and dry them well. Make sure
that no water enters the product interior (e.g. at the switches).
• Clean the edge around the door using a soft, warm and damp cloth only. To avoid penetration of
water into the door lock and electrical components, do not use a spray cleaner of any kind.
Cleaning the lter assembly
The lter prevents larger remnants of food or other objects from getting inside the pump. Inspect the
lters for blocking every time the dishwasher has been used.
13
The lter system consists of a coarse lter, a at (Main lter) and a micro lter (ne lter).
• Main lter A: Food and soil particles trapped by this lter are pulverized by a special jet on the
spray arm and washed down to drain.
• Fine lter B: This lter holds soil and food residue in the sump area and prevents it from being
deposited on the dishes during wash cycle.
• Coarse lter C: Larger items, such as pieces of bones or glass that could block the drain are
trapped in the coarse lter. To remove the items caught by the lter, gently squeeze the tap on
the top of this lter and lift out.
14
Disassemble and clean the lter according to following steps:
• Turn the lter cap (lter C) anticlockwise and take o whole lter assembly.
• Take out lters B and C.
• Take out lter C.
• Wash lters under running water.
• Reassembling is done in reverse order. Make sure the lter assembly is installed correctly.
Note: Do not use the dishwasher with lter system not installed.
Cleaning the spray arms
15
The spray arms can be easily removed for periodic cleaning of the nozzles, to prevent possible clogging.
• Grasp the middle of the spray arm, pull it upwards to remove it.
• Wash the arms under a jet of running water
• Return them carefully to their seat and make sure that the spray arms are installed correctly and
can turn freely.
ERROR CODES
Code Meaning Possible causes
The "Sanft 40°" light ickers. Longer inlet time
• Faucets is not opened
• Water intake is restricted
• Water pressure is too low
The "90 min. Programm" light ickers. Overow
• Some component of dishwasher leaks
IM_ODW121_150402_V04_HR.indb 34 2/4/15 4:24 PM
To Next Page
Loading...
