OK. OPJ 4321 - Extracting JUICE; Pulse Function; Removing Blockages

12
Size = A5
EN
9
Insert the pusher into the feeding chute. Make sure the notch of the pusher ts the ridge on the
feeding chute top.
Place the juice container underneath the spout.
Now the appliance is assembled and ready for use.
Note: Ensure that all components, esp. the metal sieve are properly assembled before using the
product.
PREPARING FRUITS AND VEGETABLES
• This juicer can be used to make juices from many dierent types of fruit and vegetables, but some
preparations are needed to create avourful and tasty juices.
• Rinse fruits and vegetables under fresh running water.
• Cut large fruits and vegetables into pieces that t into the feeding chute.
• Remove large seeds, stones, and pits from cherries, peaches, etc.
• Remove thick or hard skin from pineapple, oranges, melons, etc.
EXTRACTING JUICE
Cautions!
• Before plugging in the juicer, make sure the electrical circuit is not overloaded with other appliances.
• Always turn the juicer o and unplug it when not in use.
• Do not put your hand or ngers into the feeding chute to push food or remove clogged food. Use the
pusher only. Danger of serious injury due to the rotating blade!
10
Remove the pusher from the feeding chute.
11
Connect the power plug to a suitable electrical outlet.
12
Set the on/o switch to desired juicing speed.
Speed Description
0 O position
1 Extracting juice from soft fruits and vegetables
2 Extracting juice from hard fruits and vegetables
13
Fill the prepared ingredients into the feeding chute. Do not overload it.
Add small pieces at a time.
Fruit pulp is ejected into the pulp container. Meanwhile, the extracted juice ows through the
spout into the juice container.
Use the pusher to slowly push the ingredients through the feeding chute.
Pour small amounts into the feeding chute again and again and push it down with the pusher.
14
After use: Set the on/o switch to the 0 (o ) position.
15
1. Wait until the blade has stopped running.
2. Disconnect the power plug from the electrical outlet.
PULSE FUNCTION
Note: You can always use the pulse function for maximum power! Use this function for a maximum of
2 minutes to avoid overheating the motor!
16
1. Set the on/o switch to P and hold it to start juicing.
2. Release the on/o switch to stop juicing. The switch goes back to 0 automatically.
REMOVING BLOCKAGES
• If the blades of the sieve are clogged: Set the on/o switch to 0. Wait until the blade stops running.
• Disconnect the power plug from the electrical outlet and remove the lid.
• Clear all clogged foodstu.
IM_OPJ4321_181029_V07_HR.indb 12 29/10/18 10:43 am