What to do if the main relief valve of OKADA TOP is defective?
If the main relief valve or secondary relief valve of your OKADA Industrial Equipment is defective or has an improper set pressure, send the main relief valve to the manufacturer’s designated service factory for adjustment. Regulate the secondary relief valve to correct the set pressure. Alternatively, repair or replace the damaged spring, seat, valve, or piston.
What to do if OKADA TOP has lack of hydraulic oil?
If your OKADA Industrial Equipment is low on hydraulic oil, replenish it with the same type of oil.
What to do if my OKADA TOP has insufficient gas pressure?
If your OKADA Industrial Equipment has insufficient gas pressure in the accumulator or a damaged bladder, recharge the nitrogen gas or replace the bladder.
What to do if my OKADA TOP directional valve is damaged?
If the directional valve in your OKADA Industrial Equipment is improperly selected or damaged, repair or replace it.
What to do if OKADA TOP Industrial Equipment has improper pressure of the sealed gas?
If the sealed gas pressure in your OKADA Industrial Equipment is improper, regulate the sealed gas to the correct pressure.
How to fix foreign matter clogging in OKADA TOP Industrial Equipment piping?
If your OKADA Industrial Equipment experiences clogging due to foreign matter in the piping, disassemble and remove the foreign matter.
Diagram for hydraulic lines and procedure for setting pressure and flow.
Schedule and guidelines for regular maintenance checks.
Diagnosing and fixing starting, stopping, and irregular operation problems.
Troubleshooting reduced blow force and causes of early part wear.
Safety, procedures for disassembling, inspecting, repairing, and reassembling the breaker.
General| Brand | OKADA |
|---|---|
| Model | TOP Series |
| Category | Industrial Equipment |
| Language | English |
To Next Page