Oki C9600 Series - Remove Drum Contact Sensor Board; Release Sensor Board Tabs and Screws; Detach Drum Contact Sensor Board

41
31. Remove the OR-SGG (ID
System SNS PWB) aka
Drum Contact and Sensor
Board Assy.
31.1. Remove four
screws, one each
from the Drum
Position Home
sensors. Use a flat
blade to release
the two Toner
Shutter Home
sensors and the
Drum Up/Down
Home sensor.
31.2. Use a flat blade
screwdriver to
release the tabs
securing the main
portion of the
Drum Contact and
Sensor Board
Assy. and unplug
one connector.
Remove the board
being careful of the
drum contact
springs as they
may fall out.