7
• Once the display shows "E-3" and "rES", it reminds you check whether any
motors fail connected with control unit. Please connect the main cable again,
wait at least 5 seconds.
1.
The function can detect whether the motors are
collected normally.
● Plug detection
• Connect all the plugs.
2.
• Follow "Manual Reset" procedure.
3.
Instruction
E-3
rES
rES
With this function, you can make the control unit
to factory setting.
● Reset to factory setting
• Keep pressing "S" key till the display shows "FAC".
• Press "S" key, and the control unit restore to factory setting
(including memory position, high and low limitation positions, etc).
2.
1.
S
1.
● Anti-Collision function
• Once the desktop encounters any obstacle in its path, the screen displays
"E-2".
• The desktop will move a defined distance in opposite direction, and it would be
used normally after removing the obstacle.
S
To Next Page
Loading...
