STEP 6:
Insert both HORIZONTAL SUPPORTS ‐ WITH
SCREWS (F) into the grooves at the ends of each
SUPPORT STAND (C), as shown.
STEP 7:
Insert the CABINET BASE (G). Note: Place the
lipped side facing down. Line the cabinet base
up between the SUPPORT STANDS (C).
STEP 8:
Confirm the CABINET BASE (G) is locked
in place. Secure the SUPPORT STANDS (C)
using the SCREWS (V), as shown. Tighten
screws with screwdriver.
To Next Page
Loading...
