STEP 11:
Remove the pre‐assembled screws from the HANDRAIL
(N). Attach one of the HANDRAIL BRACKETS (M) to one
end of the handle. Insert the screw and tighten.
Repeat step above to attach the remaining bracket on the
other side.
STEP 12:
Using four BOLTS (U), WASHERS (R) and NUTS (Q), install
the assembled WORKING PLATFORM on the right side of
the cart (same side as wheels).
STEP 13:
Using four BOLTS (U), WASHERS (R) and NUTS (Q), Install
the assembled HANDRAIL on the left side of the cart
(opposite the wheels).
To Next Page
Loading...
