Distance to Destination
This feature acts as a reverse trip odometer by counting
backward from
an
estimated distance which
you
enter
before starting your trip. It also uses that information to
determine the estimated time
of
arrival.
To set, press DEST, then RESET and enter a maximum
of
four digits for the length of your trip. (Always use
whole miles or kilometers.) Then press ENTER. The
system will only accept the last four digits you enter as
your distance
to
destination.
The system will display the total distance to destination,
such as:
365
MI
TO
DEST or
587
KM TO DEST
When the system counts down to zero distance
remaining, even
if
you’re in another display, a chime
will sound and the display will show:
TRIP COMPLETE
The TRIP COMPLETE message will go off when
you
press any button, or when you turn your ignition off,
then on.
The
display returns to the mode displayed prior
to the interruption.
Estimated Time of Arrival (ETA)
ETA is based on the average speed, the date and time
of
the
day, and the estimated distance to your destination.
After you have entered your distance to destination,
press ETA to display estimated time
of
arrival, such as:
ETA TUE 1256
PM
Press
ETA
again
to
display the time to destination. The
display will show the current time as the hours and
minutes
to
destination, such as:
1250
TIME TO DEST
If
the time to destination calculation is seven days or
greater, the display will read:
TRIP OVER
7
DAYS
When the trip is complete a chime will sound and the
display will show:
TRIP COMPLETE
The trip complete message will go off when you press
any button, or when you turn your ignition off, then on.
The display returns to the mode displayed prior to the
interruption.
To Next Page
Loading...
