Elapsed
Time
(ET)
Date
Press DATE to display the date.
To
change the date,
press DATE then RESET. The following display will
appear:
When the ignition is on, the Driver Information Center
can be used
as
a
stopwatch. The display
will
show hours
and minutes. The elapsed time indicator
will
record up
to
100
hours,
then
it
will reset
to
zero and continue
counting. Press ET, and the display will show the
amount
of
time that has elapsed since the elapsed time
indicator was last reset
(not
including time
the
ignition
is off), such
as:
0
1
:OS
ELAPSED TIME
To
reset elapsed time to zero, press RESET while the
elapsed time
is
displayed.
MONTH?
XXIDDIYY
MM, DD and
YY
represent the month, date and year
you
currently have
in
your system. Check to make sure
your clock is
in
the correct AM or
PM
mode.
Notice that each key has a number. Push the key to enter
the number. The first XX’s
will
flash until
you
enter the
first digit for the
month.
You
don’t need to enter the
leading zero
if
the number is under
10.
Press ENTER
after you’ve entered the month. The display will change
to:
DAY? MM/XX/Y
Y
Set the day just as you set the month. After the day entry
is made, press ENTER, and the display
will
change to:
2-78
To Next Page
Loading...
