PWWVOL
(PowerNolume):
With the ignition
on,
push this knob to
turn
the system
on
or
off. Turn
it
clockwise to increase
the
volume. Turn
it
counterclockwise to decrease the volume.
AMD":
Press this button to change between the AM,
FMI and FM2 bands. The display
will
show which band
you are on.
If
you press this button while a tape is
playing, the tape
will
stop and the radio
will
return to
the AM or FM band that you were on.
TUNE:
Press lightly on this knob to release
it
from its
recessed position. Turn
it
to tune
in
radio stations. You
may push the knob back
in
to return
it
to its recessed
position when not
in
use.
To
Preset
Radio
Stations
The five pushbuttons labeled 1-5 can be used to preset
LIP
to 15 radio stations (five AM, five FM
1
and five FM2).
1.
Tune
in
the station you want to store.
2. Press and hold one of the five pushbuttons
until
the
display shows
a
channel number. The radio
will
mute
until
the cl1annel number is displayed. Whenever you
press that button again, the preset station
will
return.
Always check whether you're
in
AM, FMl or FM2.
SEEK
A/V:
When you press
SEEK
while playing the
radio, the radio
will
search for the
next
higher or lower
station and stop. The radio will be muted while seeking.
SCAN:
When you press SCAN while playing the radio,
the radio
will
go through each station, pausing for a few
seconds at each station. Press SCAN again to stop
on
a
station. The radio
will
be muted while scanning and
"SCAN"
will
appear on the display.
When you press SCAN and hold
it
for about two
seconds
until
the display shows "PSCAN" (Preset Scan),
the radio
will
scan only stations that you've preset with
your radio pushbuttons. Press SCAN again to stop on a
station.
RECALL:
When the ignition is off, press RECALL to
display the time. When the radio
is
on, press RECALL
to switch the display between the radio station and the
time. After five seconds the display
will
return to its
normal display.
The radio can be set
so
that either the
time
or radio
station is normally displayed when the radio is playing.
To
do
this. press RECALL to display the time or radio
station
as
desired, then hold RECALL down
untii
the
display flashes.
To Next Page
Loading...
