AR/VFM
Stereo Radio with Automatic Tone
Control and Cassette Tape Player
PWRNOL (PowerNolume):
With the ignition on,
push this knob to turn the system on
or
off.
Turn it
clockwise to increase the volume. Turn
it
counterclockwise
to
decrease the volume.
AMEM:
Press this button to change between the
AM,
FMl
and
FM2
bands. The display will show which band
you are on.
If
you
press this button while a tape is
playing, the tape will stop and
the
radio will return to
the
AM
or
FM
band that you were on.
TUNE:
Press lightly on this knob to release it from
its
recessed position. Turn
it
to
tune in radio stations. You
may push
the
knob back in to return it to its recessed
position when
not
in
use.
To
Preset Radio Stations
The five pushbuttons labeled 1-5 can be used to preset up
to
15
radio stations (five
AM,
five
FM1
and five
FM2).
1.
Tune in the station you want to store.
2.
Press
TONE
to select the setting that you prefer.
This audio system may have an optional trunk-mounted
CD changer.
If
so,
also see “Trunk-Mounted
CD
Changer” later in this section.
The digital display indicates information on time or radio
3.
Press and hold one
of
the five pushbuttons until
the
station frequency, the
AM
or FM radio band, whether the
display shows
a
channel number. The radio will mute
station is
in
stereo, and other audio system functions.
until
the channel number
is
displayed. Whenever you
press that button again, the preset station and tone
setting will return. Always check whether you’re
in
AM,
FMl
or
FM2.
3-18
To Next Page
Loading...
