SEEK
A/V:
When
you
press
SEEK
while playing a
CD,
it
will go back t.o the start
of
the
current track
if
more
than eight seconds
have
played.
If
you press
it
again, the
changer
will
go
to previous tracks. When you press
SEEK
A
it
will go to the next higher track
on
the disc.
SCAN:
When you press SCAN while playing a CD,
you'll hear
the
first few seconds
of
each selection on the
current disc. Press SCAN again to stop on
a
selection.
The
CD
will
be muted while scanning and "SCAN" will
appear on the display.
FWD
(Fast
Forward):
To
advance a CD, press and
hold this button. While
the
CD advances, elapsed time
will
be displayed to help
you
find the desired passage.
REV
(Fast
Reverse):
To reverse a CD, press and hold
this button. While the CD reverses, elapsed time
will
be
displayed to help you find the desired passage.
Random:
Press the number
5
button to enter the random
play mode. "RDM"
will
appear
on
the display.
In
the
random mode: the tracks on all loaded discs
will
be
played in random order.
If
you press PROG or
SEEK
while "RDM" is displayed, the next disc and track will
be
selected randomly.
If
you press SCAN while "RDM"
is displayed, discs and tracks
will
be scanned randomly.
Press the number
5 button again to
turn
off random and
return to normal operation.
Compression:
While playing a CD, press
NR
to turn on
compression. "COMP"
will
appear on the display.
Compression makes loud and
soft
passages more equal
in
volume. Press
NR
again to turn
off
compression.
Cassette Tape and
CD
Errors
If
"Err" or "E" and a number appear
in
the
radio display,
an error has occurred and the cassette or compact disc
temporarily cannot play.
If
the error occurred while trying to play a cassette tape,
the following conditions may have caused the error:
0
The cassette tape is tight and the cassette player
cannot turn the hubs of the cassette tape. "E10" may
be
displayed. Hold the cassette with the open end
down and try turning the right hub counterclockwise
with a pencil. Turn the tape over and repeat.
If
the
hubs do not turn easily, your cassette tape may be
damaged and should not be used
in
the cassette
player. Try
a
new tape to make sure your cassette
player is working properly.
The cassette tape is broken. "El
1"
may be displayed.
Check to see
if
your tape is broken. Try a new
cassette tape.
3-24
To Next Page
Loading...
