To
Enable the Theftlock@ Feature
The instructions which follow explain how to enter your
secret code to activate the Theftlock@ system. It
is
recommended that you read through all nine steps
before starting the procedure.
1.
Write down any three- or four-digit number from
000
to
1999
and keep
it
in
a
safe place separate from
the
vehicle.
2.
Turn the ignition to the ACCESSORY or
RUN
position.
3.
Press the PWR/VOL button to turn the radio off.
NOTE:
If
you allow more than
15
seconds to elapse
between any steps,
the
radio automatically reverts
to
time and
you
must start
the
procedure over at step
4.
4.
Press the
1
and
4
buttons together. Hold them down
until
“---”
shows on the display. Next you will use
the secret code number which you have written
down.
5.
Press the MN button and
“000”
will appear
on
the
display.
6.
Press
MN
again to make
the
last two digits agree
7. Press the
HR
button to make the first
one
or two
with your code.
digits agree with your code.
8.
After
you
have confirmed that the code matches the
one you wrote down, press AM/FM. The display will
show “rEP” to indicate that you need to repeat steps
5-7
to
confirm your secret code.
9.
Press AMEM and this time the display will show
Any time Theftlock@
is activated and the battery power
is removed, the radio
will
display
“LOC.”
“SEC” indicating that your radio is secure.
To
Unlock Theftlock@ After
a
Power
Loss
Enter your secret code as follows; pause no more than
15
seconds between steps:
1.
“LO”’ will appear when the ignition is
on.
2.
Press the
MN
button and
“000”
will appear on the
display.
3.
Press
MN
again to make the last two digits agree
with
your code.
To Next Page
Loading...
