4.
Press the
HR
button to make the first one or two
digits agree with your code.
5.
After you have confirmed that the code in the display
matches the secret code
you
have written down,
press AM/FM. “SEC” will appear
in
the display,
indicating that the radio is now operable and secure.
If the code entered to unlock Theftlock@ is incorrect, the
radio will remain locked. After eight unsuccessful
attempts to unlock
the
radio, the display will show
“InOP” (inoperative). At this point you will need
to
keep the ignition on for one hour before you may
attempt to enter another code. After three unsuccessful
attempts to unlock the radio,
the
display will show
“InOP” (inoperative) again.
If
you
forget your code or cannot unlock the radio,
contact your retailer for assistance.
To Disable Theftlock@
Enter your secret code as follows; pause no more than
15
seconds between steps:
1.
2.
3.
4.
5.
4.
7.
Turn the ignition to the ACCESSORY or
RUN
position.
Press the PWR/VOL button to
turn
the radio off.
Press the
1
and
4
buttons together. Hold them down
until
“SEC” shows
in
the display.
Press the MN button and
“000”
will appear on the
display.
Press MN again to make the last two digits agree
with your code.
Press the
HR
button to make
the
first one or two
digits agree with your code.
After you have confirmed that the code in the display
matches the secret code you have written down,
press AMEM. The display will show
“---”
indicating that the radio
is
no longer secured.
If
the code entered
is
incorrect,
“SEC”
will appear
in
the
display. The radio
will
remain secured until
the
correct
code is entered.
3-27
To Next Page
Loading...
