4.
Check to make sure the safety belts are properly
routed and that
no portion of any safety belt is
trapped under
the
seat. Also make sure
the
seat
cushion
is
secured.
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by
a
combination of fuses and circuit
breakers. This greatly reduces the chance
of
damage
caused by electrical problems.
There are three main fuse panels.
Two
are located under
the rear seat.
To
access these panels, you’ll need to
remove the seat. See the previous description under
“Removing
the Rear Seat Cushion” to see how. This
procedure
is
somewhat difficult.
You
may
wish to have
your retailer replace the fuse, instead.
V
Once the seat is removed,
you’ll find two fuse panels
on the driver’s side of the
battery. Each
is
protected by
a plastic box with four tabs.
Pull up on all four tabs at
the same time to loosen
them and pull off the box.
Of these two panels, the cover on the passenger-side
fuse panel
has
an
extra plastic cap attachment.
You’ll
need
to
slide this out
of
the grooves which hold
it
there
before removing the rest
of
the box.
To
replace the covers, line the four tabs
up
and simply
snap
them
back into place. The extra plastic cap
attachment slides back into place.
6-54
To Next Page
Loading...
