EasyManua.ls Logo

Oldsmobile 1997 88 - Delayed Locking

Oldsmobile 1997 88
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.
5.
Press the LOCK button on the transmitter again. Each
time the transmitter’s LOCK button is pressed, the
mode
will
advance by one, going from
3
to
0
to
1,
etc.
Note: The door locks will cycle according to the
mode entered while customizing the memory door
locks. (Mode
“0”
has no feedback).
Release the power door lock switch. The
automatic door locks will remain
in
the most
recent mode selected.
This procedure changes the mode for only the
transmitter used to change this setting. The procedure
will need to be repeated for the second transmitter.
Delayed
Locking
This
feature lets the driver delay the actual locking
of
the vehicle. When the power door lock switch is pressed
with the key removed from the ignition and the driver’s
door open, a chime will sound three times to signal that
the lock delay mode is active. When all doors have been
closed, the doors will lock automatically after five
seconds.
If
any door is opened before this, the
five-second timer will reset itself once
all
the doors
have been closed again.
Pressing the door lock switch twice within two seconds
will override this feature.
Personalization Programming
The delayed locking feature can be turned on or
off
for
each driver’s remote lock control transmitter.
To
turn
the feature on:
1.
Press and hold LOCK on the driver’s power door lock
switch throughout
this
procedure.
All
the doors
will
lock.
2.
Press the UNLOCK button on the transmitter. The lock
delay is
still
off
and
all
doors will remain locked.
3.
Press the UNLOCK button on the transmitter again.
Lock delay
is
now active and all doors will unlock.
4.
Release the power door lock switch.
This
procedure changes the mode for only the
transmitter used to change this setting. The procedure
will need to be repeated for the second transmitter.
If
your vehicle is not equipped with the remote lock
control, use the following procedure to
turn
the feature on:
1.
2.
3.
With the ignition on, press and hold LOCK on the
driver’s power door lock switch. All doors will lock.
Toggle the headlamps switch four times (off to on
is
one toggle). The doors will unlock to confii that
the feature is now
on.
Release the power door lock switch.
To
turn
the feature
off,
repeat the previous procedures.
2-6

Related product manuals