yellowblue
6-35
5. Carefully remove the backplate by pulling the four
outer tabs and two inner tabs sideways away from
the backplate.
6. Gently wiggle the bulbs to remove them from the
socket. Replace the bulb.
7. Reverse the steps to reassemble the rear lamp
assembly and mount to the car.
Make sure that all six tabs are securely fastened to
the backplate before reassembling the lamp.
8. When securing the lamp back into place, align the
lamp so that the trunk lid doesn’t contact it.
Dome Lamp
To change your dome lamp bulb, grasp the center front
and center rear portion of the housing and squeeze
firmly but gently. The housing should pop off.
If this doesn’t work, you may need to use a small
flat
-head screwdriver under the side of the housing to
help pry it off.
To Next Page
Loading...
Need help?
General
