2-62
Training a Garage Opener with a
“Rolling Code” Feature (If Equipped)
If you have not previously programmed the hand-held
transmitter of HomeLink, see “Programming the
HomeLink Transmitter” listed previously. If you have
completed this programming already, you now need to
train the garage door opener motor head unit to
recognize HomeLink.
1. Find the “Learn” or “Smart” button, refer to
your garage door opener owner’s manual or contact
the manufacturer of HomeLink at 1
-800-355-3515
or on the internet at www.homelink.com.
Because of the steps involved, it may be helpful
to have another person assist in programming
the transmitter.
2. Press the “Learn” or “Smart” button on the garage
door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
training mode.
Following this step, you have 30 seconds to start
Step 3.
3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink
button three times.
The rolling
-code garage door opener should now
recognize HomeLink. You may either use HomeLink or
the hand-held transmitter to open the garage door.
If after following these instruction, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
-800-355-3515, or on
the internet at www.homelink.com.
To Next Page
Loading...
