3-3
Mode Buttons
Each button has an indicator which will glow when the
button is pressed.
(Vent): This setting directs air through the
instrument panel outlets.
(Bi-Level): This setting directs air two ways. Half
of the air is directed through the instrument vent outlets.
Most of the remaining air is directed through the floor
ducts and a little to the defrost and side window vents.
(Floor): This setting sends most of the air
through the ducts near the floor. The rest comes out
of the defroster and side window vents. When using
this setting in the recirculation mode, the windows
may fog up. See “Recirculation” in the Index for
more information.
(Defogger): This setting allows half of the air to go
to the floor ducts and half to the defrost and side
window vents. The air conditioning compressor will run
automatically in this setting unless the outside
temperature is below 38
_
F (3.3
_
C). Even when the
compressor is running, you can control the temperature.
(Defroster): This setting directs most of the
air through the defrost and side window vents. Some
of the air goes to the floor ducts. The air conditioning
compressor will run automatically in this setting unless
the outside temperature is below 38
_
F (3.3
_
C). Even
when the compressor is running, you can control
the temperature.
A/C (Air Conditioning): Press this button to
operate the air conditioning compressor. An indicator
light in the button will flash briefly and then stay on to
let you know that the air conditioning is on. If the light
in the A/C button turns off after the flashing has
stopped, the air conditioning is not on. The air
conditioning will not come on for two reasons:
D
The outside temperature is below 38
_
F (3.3)
_
C).
D
The refrigerant pressure is too low or too high. See
“Air Conditioning Refrigerants” in the Index.
To Next Page
Loading...
Need help?
General
