Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons
until
the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Training a Garage Opener with a “Rolling
Code” Feature
If
you programmed the universal transmitter, but the
garage door will not open, and
if
your garage door opener
was manufactured after 1995,
YOLK
garage door may have
a security feature that changes the “code” of your garage
door opener every time
it
is opened or closed.
To
determine
if
your garage door opener has this
“rolling code” feature, press the appropriate button on
the universal transmitter that was programmed.
If
the
red light flashes rapidly for one
to
two seconds, then
turns solid, your garage door opener has this feature.
To
program a garage door opener- with the rolling code
feature, do the following:
1.
Program your hand-held transmitter to the universal
transmitter by following the steps provided under
“Programming the Transmitter” earlier
in
this
section.
2.
3.
4.
5.
6.
Remove the cover panel from the garage door opener
receiver.
It
is located near the garage door opener motor.
Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands.
Press the training button on the garage door opener
receiver for one to two seconds.
Return to your vehicle and press the programmed
button on the universal transmitter
until
the red light
flashes rapidly (about two seconds).
Release the button, then repress
it
to confirm
it
was
programmed to the garage door opener receiver.
You may now use either the universal transmitter or the
hand-held transmitter to open your garage door. If you
still have difficulty
in
programming and require
assistance, please call 1-800-355-35 15.
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the
unit.
If
you would like
additional information, please call 1-800-355-35
15.
2-47
To Next Page
Loading...
