Finding a Station
AM-FM:
Press the lower knob to switch between
AM
and
FM.
The display shows your selection.
TUNE: Turn the lower knob to tune in radio stations.
SEEK: Press this button to
go
to
the
next higher station
and stop.
SCAN:
Press this button to listen to each station for
a
few seconds. The radio will
go
to the next station, stop
for a few seconds, then
go
to the next station. SCAN
will appear on the display. Press SCAN again to
stop scanning.
PUSHBUTTONS: The four numbered pushbuttons let
you return to your favorite stations.
You
can set up to
14
stations (seven AM and seven
FM).
Just:
1.
Turn
the
radio on.
2.
Press
AM-FM
to select the band.
3.
Tune in the desired station.
4.
Press
SET.
(SET
will appear on the display.)
5.
Press one
of
the
four pushbuttons, within five
seconds. Whenever you press that numbered button,
the station you set will return.
6.
Repeat the steps for each pushbutton.
In addition to the four stations already set, up to three
more stations may be preset on each band by pressing
two adjoining buttons at the same time. Just:
1.
Tune in the desired station.
2.
Press SET. (SET will appear on
the
display.)
3.
Press two adjoining pushbuttons at the same time,
within five seconds. Whenever you press the same
two buttons, the station you set will return.
4.
Repeat the steps for each pair of pushbuttons.
Setting the Tone
TONE ADJUSTMENT
Set
the
bass, midrange and
treble by using the levers
in
the upper middle left corner
to get the sound you want. The
60
and
250
levers adjust
the bass,
1
K
is midrange, and
the
levers
3.5K
and
10K
control the treble.
We suggest you start with
1K
in
the midpoint position.
Then
move the other levers up
until
you get the amount
of bass and treble you like.
3-7
To Next Page
Loading...
