Center High-Mounted Stoplamp
1.
Remove the two screws.
2.
Pull the lamp assembly out.
3.
Turn the socket counterclockwise and pull
it
out.
4.
Holding the base
of
the bulb, pull the bulb straight
out
of
the socket.
5.
Reverse the steps to install
a
new bulb.
Taillamps
1.
Open the endgate.
2.
Remove the two screws
from the lamp assembly.
4.
5.
6.
7.
8.
9.
Turn the socket counterclockwise to remove
it.
Push
the tab
in
while you turn the socket
counterclockwise.
Holding the base
of
the bulb, pull the bulb straight
out
of
the socket.
Push the new bulb straight into the socket until it clicks.
Put the socket into the lamp assembly and turn the
socket clockwise
until
it
locks into place.
Install the lamp assembly and screws.
Close the endgate.
Underhood Lamp
1.
Disconnect the electrical connector from the
underhood lamp assembly.
2.
Remove the screws.
3.
Disconnect the ground wire.
4.
Remove the lamp assembly
from
the hood.
5.
Install the new bulb.
6.
Replace the assembly. Install and tighten the screws.
7.
Connect the ground wire.
8. Connect the electrical connector to the
lamp
assembly.
3.
Pull the assembly away from the vehicle.
6-32
To Next Page
Loading...
