2.
Press down on
the
blade assembly pivot locking tab.
Pull down on the blade assembly to release
it
from
the wiper arm hook.
insert has two notches at one end that are locked by
the bottom claws
of
the blade assembly. At the
notched end, pull the insert from
the
blade assembly.
3.
Remove the insert from the blade assembly. The
5.
Be sure that the notches are locked by the bottom
claws. Make sure that
all
other claws are properly
locked on both sides
of
the insert slots.
A
4.
To
install the new wiper insert, slide
the
insert (D),
notched end last, into the end with two blade claws
(A).
Slide the insert all the way through
the
blade
claws at the opposite end
(B).
The plastic caps
(C)
will be forced off
as
the insert is
fully
inserted.
A.
Claw
in
Notch
B.
Correct Installation
C.
Incorrect Installation
6-35
To Next Page
Loading...
