Oleo-Mac BC 22 TR - User Manual

Questions and Answers

L
lacey17Aug 1, 2025
What to do if my Oleo-Mac BC 22 TR Lawn and Garden Equipment engine does not reach full speed and emits excessive smoke?
- A
  awalkerAug 1, 2025
  If your Oleo-Mac Lawn and Garden Equipment engine isn't reaching full speed and is emitting excessive smoke, here's what you should do: 1. Ensure you're using fresh fuel and the correct 2-cycle oil mix. 2. Clean the air filter according to the instructions in the Maintenance-Air Filter Section. 3. If the problem persists, the carburetor may need adjustment, so contact a Servicing Dealer.
W
Wanda GeorgeAug 7, 2025
What to do if my Oleo-Mac BC 22 TR engine will not start?
- S
  Shelley CraigAug 7, 2025
  If your Oleo-Mac Lawn and Garden Equipment engine won't start or runs only briefly, here's how to troubleshoot: 1. Check for a spark at the spark plug tip. If there's no spark, try again with a new spark plug (CMR7H). 2. If the engine is flooded, follow the procedure on page 28. If it still won't start, try the procedure again with a new spark plug.
R
Rebecca FosterAug 13, 2025
Why does my Oleo-Mac BC 22 TR Lawn and Garden Equipment engine start but will not accelerate properly?
- B
  Bradley CortezAug 13, 2025
  If your Oleo-Mac Lawn and Garden Equipment engine starts but does not accelerate properly or run correctly at high speed, it is likely that the carburetor requires adjustment. Contact a Servicing Dealer to have the carburetor adjusted.
T
Thomas LloydAug 19, 2025
What to do if my Oleo-Mac Lawn and Garden Equipment engine starts, runs, and accelerates but will not idle?
- S
  Spencer GarrettAug 20, 2025
  If your Oleo-Mac Lawn and Garden Equipment engine starts, runs, and accelerates but won't idle, turn the idle speed screw “T” (Fig. 21) clockwise to increase the idle speed. Refer to the Operation-Carburetor Adjustment section for further guidance.
D
David BrandtAug 26, 2025
What to do if my Oleo-Mac Lawn and Garden Equipment engine starts and runs, but the cutting attachment is not rotating?
- C
  Christine WalkerAug 26, 2025
  If your Oleo-Mac Lawn and Garden Equipment engine starts and runs, but the cutting attachment isn't rotating, it could be due to damaged clutch, bevel drive, or transmission shaft. Contact a Servicing Dealer to replace these parts if necessary.