To Next PageTo Next PageHow to fix an Oleo-Mac Tiller that doesn't work when the clutch lever is engaged?
If your Oleo-Mac Tiller isn't working even when the clutch lever is engaged, it might be due to the belt being extended and slipping. To resolve this, adjust the belt tension.
What to do if the differential is absent when the lever is ON in my Oleo-Mac Tiller?
If there's no differential action when the lever is ON in your Oleo-Mac Tiller, it's likely that the differential wire is extended. The suggested solution is to adjust the differential cable.
What to do if there is mud or grass around the resistance stake of my Oleo-Mac Tiller?
If you find mud or grass coiled around the resistance stake of your Oleo-Mac Tiller, remove the mud or grass from the resistance stake and apply engine oil to the stake.
What to do if the resistance stake is touching the ground on my Oleo-Mac Tiller?
If the resistance stake is touching the ground on your Oleo-Mac Tiller, activate the lever while lifting the handlebar.
Familiarize with correct operation and controls before using the machine.
Inspect the work area and machine, check for worn or damaged parts before use.
Adhere to recommendations, avoid hazards, and use appropriate attire during operation.
Actions to take in case of abnormal vibrations, blockages, or impacts.
Identification of critical safety symbols related to general dangers and rotating parts.
Symbols indicating the engaged and disengaged positions of the clutch lever.
Symbols showing the different gear selections and neutral position.
Symbols for wheel drive, accelerator, and ignition key functions.
Symbol indicating a general warning to read the instruction manual.
Information regarding the use of accessories with the machine and potential warranty issues.
Step-by-step guide for attaching the handle to the machine body.
Instructions for connecting the clutch cable to the handle and lever.
Procedure for fitting the upper shift lever extension with a cotter pin.
Method for securing the wiring harness and control wires to the handle using bands.
Guide for filling the engine with the correct type and quantity of oil before first use.
Instructions for filling the transmission with the specified EP SAE 80W 90 oil.
Guidelines for filling the fuel tank with fresh, unleaded gasoline.
How to adjust the handle height to one of three available positions.
Steps for mounting the tines (blades) onto the tine holder correctly.
A checklist of essential checks before operating the machine for safety and performance.
Detailed steps for starting the engine, including fuel, choke, and ignition settings.
Procedure for starting the machine after the engine is running, using clutch and shift levers.
Steps to safely stop the machine's operation and shut down the engine.
How to turn the machine using the differential lever and tines.
Adjusting the depth stake to control the tilling depth.
Adjusting the resistance stake for different soil conditions and tilling modes.
Explains the function of the differential lever for turning and traction.
How to perform tilling operations using the shift lever and clutch.
How to adjust the drive belt tension for optimal performance and safety.
Adjusting the differential cable for proper locking and operation.
Guidance on checking and replacing worn or damaged tines for efficient tilling.
Importance of keeping the engine clean for air cooling and preventing overheating.
How to check and adjust the spark plug gap, and when to replace it.
Procedures for draining and refilling the engine oil.
Steps for cleaning and maintaining the air filter for proper engine function.
Instructions for storing the tiller properly during long periods of inactivity.
A guide to identify and resolve common problems encountered with the tiller.
General| Engine Type | 4-stroke |
|---|---|
| Power Output | 5.7 HP |
| Tilling Width | 50 cm |
| Starting System | Recoil starter |
| Displacement | 182 cc |
