EasyManua.ls Logo

Oleomac BCH 40 - User Manual

Oleomac BCH 40
128 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GB
F
E
RUS
HR
UA
OPERATOR’S INSTRUCTION BOOK
MANUEL D’UTILISATION ET D’ENTRETIEN
MANUAL DE USO Y MANTENIMIENTO
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИ
UPUTSTVA ZA KORIŠTENJE I ODRŽAVANJE
ПЕРЕКЛАД ОРИГІНАЛЬНИХ ІНСТРУКЦІЙ ВСТУП
BCH 40 - DSH 400
(40.2 cm
3
)

Table of Contents

Questions and Answers

  • M
    Matthew JohnsonAug 11, 2025
    Why does my Oleomac BCH 40 engine not reach full speed and emits excessive smoke?
    • W
      whitestephanieAug 11, 2025
      There are several reasons why your Oleomac Trimmer engine might not reach full speed or emits excessive smoke: * Check the fuel mixture. Use fresh fuel and the correct 2-cycle oil mix. * The air filter might be dirty. Clean it according to the instructions in the Maintenance-Air Filter Section. * The carburetor may require adjustment. Contact a Servicing Dealer for carburetor adjustment.
  • L
    Leslie ShermanAug 17, 2025
    What to do if my Oleomac Trimmer engine will not start or runs only a few seconds?
    • K
      Kevin WrightAug 18, 2025
      If your Oleomac Trimmer engine won't start or only runs briefly, the issue might be: * No spark: Check for a spark at the spark plug tip. If there's no spark, try again with a new spark plug (TORCH L6RTC). * Flooded engine: Follow the procedure on page 7. If it still doesn't start, try again with a new spark plug.
  • C
    Christopher WheelerAug 25, 2025
    What to do if my Oleomac BCH 40 Trimmer engine starts but will not accelerate properly?
    • C
      Carrie HoltAug 25, 2025
      If your Oleomac Trimmer engine starts but won't accelerate properly or run well at high speed, the carburetor may need adjustment. Contact a Servicing Dealer for carburetor adjustment.
  • B
    Bryan FisherAug 29, 2025
    What to do if my Oleomac Trimmer engine starts, runs, and accelerates but will not idle?
    • D
      Donald BeckerAug 29, 2025
      If your Oleomac Trimmer engine starts, runs, and accelerates, but won't idle, turn the idle speed screw “T” (Fig. 16) clockwise to increase the idle speed. See Operation-Carburetor Adjustment.
  • L
    lcollinsSep 4, 2025
    What to do if my Oleomac Trimmer engine runs, but the cutting attachment is not rotating?
    • S
      stephanie08Sep 4, 2025
      If the Oleomac Trimmer engine runs, but the cutting attachment isn't rotating, the clutch, bevel drive, or transmission shaft might be damaged. Replace if necessary - contact a Servicing Dealer.

Oleomac BCH 40 Specifications

General IconGeneral
BrandOleomac
ModelBCH 40
CategoryTrimmer
LanguageEnglish