What to do if the 'Add Water' indicator lights up on my oline GSN-Z1?
If the 'Add Water' indicator is illuminated, the ice maker has stopped because of a lack of water. You should add water and then press the 'ON/OFF' button to restart the ice-making process. Also check and clean the filter screen at the bottom of the water tank, and adjust the position of the induction needle if it's not in the middle of the hole.
Why is the “ICE FULL” indicator on my oline GSN-Z1?
The “ICE FULL” indicator turns on because either there is too much ice in the ice basket, the ice full sensor is faulty, or water has infiltrated the induction lamp. To resolve this, remove some ice and restart the ice maker by pressing the 'ON/OFF' key. Also, try cleaning the sensor and adjusting the position of the induction needle.
How to fix my oline Ice Maker when it's cycling normally but not making ice?
If your ice maker is running its cycle but not producing ice, this could be due to high ambient or water temperatures. Ensure the room temperature is below 89°F and use cold water in the water tank. If the issue persists, there may be a leakage or clogging in the refrigeration system, requiring you to contact customer service.
To Next Page
General