EasyManua.ls Logo

Olsberg Levana 43/147 User Manual

Olsberg Levana 43/147
100 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Levana Arina
Pellet-Kaminofen Levana 43/147 + 43/148
Pellet-Kaminofen Arina 43/156 + 43/158
- DIN EN 14785
- DIN EN 18897 raumluftunabhängig
- DIBt - Bauaufsichtliche Zulassung
- 15a BV-G
Anleitung Seite ......2 - 35
Instruction Page ....36 - 65
Instructions Page ....66 - 99
D
GB
F

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Olsberg Levana 43/147 and is the answer not in the manual?

Olsberg Levana 43/147 Specifications

General IconGeneral
CategoryStove
BrandOlsberg
ModelLevana 43/147
Fuel TypeWood
Flue Diameter150 mm
Width430 mm
Depth430 mm

Summary

Introduction to the Pellet Stove

General Safety Warnings

Important safety precautions for operating the appliance, including warnings for children and unsupervised use.

Technical Data Specifications

Key technical specifications of the pellet stove, including output, dimensions, and power supply.

Regulations and Standards Compliance

Overview of regulations and standards that must be observed for installation and operation.

Chimney Dimensioning Guidelines

Information on how to dimension the chimney according to standards and heat output.

Combustion Air and Stove Installation

Combustion Air Supply Requirements

Details on ensuring sufficient combustion air, including room-air independent options.

Installation Sequence Steps

Step-by-step guide for the physical installation of the pellet stove.

Modifying Combustion Air Duct

Instructions for adapting the combustion air duct for bottom connection.

Commissioning and Initial Operation

Permissible Fuel and Filling

Information on approved pellet types and safe procedures for filling the pellet tank.

General Operating Conditions

Explanation of how the stove operates and factors influencing performance.

Pre-Heating Instructions

Crucial steps to follow before the initial heating cycle to ensure proper function.

Touch Control Panel Interface

Understanding the Touch Controls

General information and explanation of the functions of each operating key on the touch panel.

Interpreting Display Screens

Guide to understanding the various status indicators and information displayed on the screen.

Displaying Operating Status Modes

Explanation of different operating status modes like 'off', 'standby', 'ignition', 'heating', and 'cleaning'.

Appliance Connection and Commissioning

Connecting the Appliance

Instructions for connecting the pellet stove to the power supply and any accessories.

Initial Commissioning Steps

Procedure for the initial setup and activation of the pellet stove.

Menu Navigation and Operation Modes

Selecting Menu Options

How to navigate through the appliance's menu system to access different functions.

Configuring Operation Modes

Guide to selecting and setting the 'manual' or 'automatic' operation modes.

Detailed Appliance Settings

Time Program Settings

Configuring daily and weekly time programs for automated heating cycles.

Frost Protection Setup

Setting the temperature to activate frost protection mode automatically.

Maximum Power Level Adjustment

Setting the maximum heating power level for the appliance.

Standby Mode Configuration

Options for configuring the appliance's standby operation.

Advanced Settings and Information

Temperature Off and Delay Settings

Configuring temperature thresholds for switching off and delay timers.

GSM Module Configuration

Information and settings related to the optional GSM module for remote operation.

System Information Overview

Accessing information like software version, service intervals, and operating hours.

Error Message Log

Viewing the history of the last recorded error messages for troubleshooting.

Manual Operation Mode

Automatic Operation Mode

Time Program Configuration

Date and Time Settings

Language and Convection Settings

Language Selection

Choosing the display language for the appliance interface.

Convection Air Blower Settings

Configuration options for the convection air blower, including speed control.

Frost Protection Temperature

Setting the specific temperature threshold for activating frost protection.

Night Set and Power Settings

Night Set Temperature Configuration

Setting a lower temperature for nighttime operation in automatic mode.

Maximum Power Level Setting

Adjusting the maximum power output level for the appliance.

Standby Mode Operation

Configuring the appliance's behavior when entering standby mode.

Temperature Drop and Off Settings

Temperature Drop for Standby

Defining the temperature difference for switching back on from standby.

Temperature Off Hysteresis

Setting the temperature hysteresis for switching the appliance off in standby.

Delay Settings and System Information

Delay Setting for Room Thermostat

Configuring a delay for thermostat response to prevent rapid cycling.

Software Version Information

Displaying the current software version of the appliance's control system.

Service Interval Information

Details on upcoming service requirements based on operating hours.

Operating Hours Tracking

Displaying the total operating hours of the appliance since commissioning.

External Requests and GSM Module Status

External Request Status

Checking the status of external control signals, like from a room thermostat.

GSM Module Status

Information on whether the GSM module is installed and its operational status.

Recent Error Messages

Reviewing the log of the last five error messages for diagnostics.

Operating Data and Service Prompt

Real-time Operating Data

Displaying live data such as flame temperature, fan speed, and heat power.

Child Safeguard Activation

Instructions for activating and deactivating the child lock feature.

Service Maintenance Prompt

Notification and procedure for required appliance servicing.

Detailed Error Message Reference

Warning Message Explanations

Emergency and Operational Procedures

Chimney Fire Response

Steps to take in the event of a chimney fire.

Power Failure Handling

How the appliance behaves during and after power outages.

Recommissioning After Interruption

Procedure for restarting the appliance after a prolonged shutdown.

Stone Cladding Description

Information about the natural stone cladding and its characteristics.

Inspection Door Access

Details on how to open and close the appliance's inspection door.

Appliance Cleaning and Maintenance

Spare Parts and Accessories

Ordering Spare Parts

Guidelines for requesting and ordering original spare parts for the appliance.

Convection Air Blower Accessory

Information on the optional convection air blower for improved heat distribution.

Remote Control Accessory

Details on the infrared remote control for basic appliance functions.

GSM Module Accessory

Information about the GSM module for SMS operation and app control.

Room Thermostat Accessory

Description of the external room thermostat for temperature regulation.

Technical Diagrams and Connections

Electrical Connection Diagram

Schematic showing the electrical connections for the appliance and accessories.

Terminal Assignment for Plugs

Detailed breakdown of terminal assignments for various plugs and connections.

Commissioning Certificate Document